In nearly all cases, most people spend quite a lot of money purchasing their forklift. Hence, it is really essential to take proper care of it so as to protect your investment well into the long run. It is a great idea to know the procedures which are carried out in maintaining and taking care of this machine.
One of the best ways to tell how good the engine is working is by starting the forklift up and listening closely to see how it works. For example, if there are any misses or knocks, the equipment is defective and this should raise some issues. Also listen closely for any squealing sounds which come from the belts because these sounds will provide you with a lot of information.
When carrying out maintenance, some of the main components you would have to pay attention to consist of the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above components have been checked thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell has to be inspected so as to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters should be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Next, check each and every other part of the machine including the wheels. If any type of fault or issue is detected, be certain to address it immediately so as to make certain the machinery is running at its safest and optimum levels.